We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
Vi utviklet dette praktiske verktøyet for å hjelpe med å løse den evige marerittet for omreloadere; å fjerne en hylse som sitter fast i størkedyse. Dette skjer når kanten av hylsen rives av under nedslaget, noe som etterlater hylsekroppen i dysen, uten noe å gripe tak i for å trekke den ut. Sinclair Stuck Case Removal Tool lar deg fjerne den fastsittende hylsen fra enhver standard størkedyse uten risiko for å skade dysen. Bare fjern dysen fra pressen og trekk ut avtrekkerstiften til den er ute av tennhullet. Klem dysen i en skrustikke og