Attributes
- Modell: Universal Handguns
- Våpentype: Glock
- Leveringsvekt: 0,054kg
- Frakthøyde: 25mm
- Fraktbredde: 51mm
- Fraktlengde: 159mm
- UPC: 955728100917
Produktnr.: 100019863
Produsentnr.: GMRT-01
955728100917 Nå kan du holde magasinbrønnen i perfekt stand og fungere som en kamp-pistol skal med vårt GMRT-01 verktøy. Den spesialformede tuppen er utformet for å frigjøre magasinutløserfjæren med maksimal grep og moment. Du vil merke at den avrundede tuppen også er høypolert rustfritt stål, som ikke kan skade magasinbrønnen eller magasinutløseren…noensinne. Det ergonomiske håndtaket er også i rustfritt stål for langvarig, korrosjonsfri bruk. Verktøyet fungerer også på enhver pistol med Glock-stil magasinutløser, som Smith & Wesson M&P, osv. Det ultimate Glock-verktøyet for våpensmeder, armorere og skyttere som har flere magasinutløserinstallasjoner i ett tilfelle eller for detaljert regelmessig vedlikehold.Med vårt GMRT-01 verktøy kan du holde magasinbrønnen i perfekt stand og sørge for at den fungerer som en kamppistol skal. Den spesialformede spissen er utformet for å frigjøre magasinutløserfjæren med maksimal grep og moment.
Den avrundede spissen er også laget av høypolert rustfritt stål, som ikke kan skade magasinbrønnen eller magasinutløseren… noensinne. Det ergonomiske håndtaket er også i rustfritt stål for langvarig, korrosjonsfri service.
Verktøyet fungerer også på enhver pistol med Glock-stil magasinutløser, som Smith & Wesson M&P, osv. Dette er det ultimate Glock-verktøyet for våpensmeder, armorere og skyttere som har flere magasinutløserinstallasjoner i én økt eller for detaljert, regelmessig vedlikehold.
Nice Tool 09.10.2018
I have to deduct a star for no instructions included with the tool. Other than that, the tool works as advertised. The tip is flat on one side and round on the other, like a half-round file. Based on my limited experience with the tool, and assuming I'm using it correctly, the flat side is used to remove spring tension, while the round end works best for loading the spring tension. To remove, insert the tool into the magwell from the right side of the pistol, put the flat end against the spring, then while holding the mag catch in place, pull the spring left to right, then rotate your wrist and the spring pops right out of its slot in the mag catch. To install, insert the tool into the mag well from the left side of the pistol, put the round edge against the spring, then while holding the mag catch in place push the spring left to right, and the spring will automatically fall into its slot in the mag catch. Couldn't be simpler... but alas, it is a limited-use specialty tool. Sure as heck beats a screwdriver, though! I like it.
Perfect 24.07.2018
Perfectly designed tool to remove, replace, or reverse magazine release without damaging your Glock
Vi opplevde en feil under innlasting av dette innholdet. Vennligst last inn siden på nytt for å fortsette. Hvis problemet vedvarer, ta kontakt med kundeservice.