The Lee APP Bulge Buster Kit and the appropriate Lee Carbide Factory Crimp Die restores free function of rimless cases that have low base bulges. Low base bulges usually occur from chambers that do not fully support the cartridge or cases resized in carbide dies from manufacturers other than Lee. These show a noticeable stop ring near the base. You will most likely find cases with these problems in mixed range brass. The Lee Carbide Factory Crimp Die must be purchased separately. **Will work with the following cases: 380 ACP, 10mm, 40 S&W, 41 AE (Use 40 S&W Factory Crimp Die), 45 ACP, 45 GAP, and 45 Win Mag.
Lee APP Bulge Buster Kit og den passende Lee Carbide Factory Crimp Die gjenoppretter fri funksjon av rimless patroner som har lav base bulger. Lav base bulger oppstår vanligvis fra kammer som ikke fullt ut støtter patronen eller patroner som er omformet i carbide dies fra produsenter annet enn Lee. Disse viser en merkbar stopp ring nær basen. Du vil mest sannsynlig finne patroner med disse problemene i blandet rekke messing. Lee Carbide Factory Crimp Die må kjøpes separat. **Vil fungere med følgende patroner: 380 ACP, 10mm, 40 S&W, 41 AE (bruk 40 S&W Factory Crimp Die), 45 ACP, 45 GAP, og 45 Win Mag.