When a standard AR-15 is converted to .22lr through a conversion bolt or replacement upper, the bolt catch stops working. The Catch22 V2 slides over a stock AR-15 bolt catch to work with most common .22lr conversions and give you bolt catch functionality again. To install, just slide the Catch22 over the stock bolt catch and you're ready to go. This allows you to easily swap between calibers without the need for any tools. The bolt catch is compatible with CMMG, RTB, Spike's Tactical, Tactical Solutions dedicated upper receivers and conversion bolts, as well as similar Ceiner kit conversion bolts. For the bolt catch to provide true last-round-hold-open, the magazine that is used needs to have a follower that sticks out of the back and will engage the bolt catch after the last round. Because of this, different magazines will offer different last round functionality. - CMMG / Black Dog ""Standard"" (X-form, Sonic Weld, etc.): These magazines have a follower that sticks up after the last round is fired, but it doesn't reach out of thee back which is required to hit the bolt catch. The bolt catch will need to be manually engaged to hold the bolt back after the magazine is removed. - S&W 15-22: These magazines have a follower that can hit the bolt catch consistently after the last round is fired and are the best way to get last-round-hold-open functionality. These magazines need to be shimmed using a Catch22 clip-on adapter to take up the slack in the magwell as they are more slim than a standard AR magazine.
Når en standard AR-15 konverteres til .22lr gjennom en konverteringsbolt eller erstatningsoverdel, slutter boltfangeren å fungere. Catch22 V2 glir over en standard AR-15 boltfanger for å fungere med de vanligste .22lr konverteringene og gi deg boltfangermulighet igjen. For å installere, bare glid Catch22 over den originale boltfangeren, så er du klar til å gå. Dette lar deg enkelt bytte mellom kalibre uten behov for verktøy. Boltfangeren er kompatibel med CMMG, RTB, Spike's Tactical, Tactical Solutions dedikerte overdel og konverteringsbolter, samt lignende Ceiner kit konverteringsbolter. For at boltfangeren skal gi ekte siste-runde-hold-åpen, må magasinet som brukes ha en follower som stikker ut bak og vil engasjere boltfangeren etter den siste runden. På grunn av dette vil forskjellige magasiner tilby ulik funksjonalitet for siste runde. - CMMG / Black Dog ""Standard"" (X-form, Sonic Weld, osv.): Disse magasinene har en follower som stikker opp etter den siste runden er avfyrt, men den når ikke ut bak, noe som er nødvendig for å treffe boltfangeren. Boltfangeren må aktiveres manuelt for å holde bolten tilbake etter at magasinet er fjernet. - S&W 15-22: Disse magasinene har en follower som konsekvent kan treffe boltfangeren etter den siste runden er avfyrt, og er den beste måten å oppnå funksjonalitet for siste-runde-hold-åpen. Disse magasinene må shims med en Catch22 clip-on adapter for å ta opp slacken i magwell, da de er slankere enn et standard AR-magasin.